I am just a curious party on the internet and I’m looking on my phone so have done less deep digging than I would do at a desk.
Searching for Beko WMD service manual lead me to a site, elektrotanya.com where I got a file called beko_wmd_25121_t.rar which has exploded parts diagram and a fault code flowchart.
The flowchart says the following which may or may not be useful re resetting fault code.
FAILURE CODE OBSERVING MODE
Entrance:
Press the first auxiliary function button from the left for 6 seconds. “Run/
Pause/Cancel” led will start blinking and the program followers will start
blinking as an error code for 3 seconds if any failure routine has run.
After 3 seconds, the machine will return to the selection mode.
Deletion of the error code:
After entering the failure code observing mode, pressing and holding “Run/
Pause/Cancel” button for a short time will erase the error code from the
memory. After you complete your inspection, if you are not sure that you
have solved the problem and if you are going to change the electronic card
group, do not erase the error code. For else cases, you may erase the error code.
The flow chart has details of the code flashings which I can give if helpful and you don’t acquire the document yourself.
Apologies if you’ve already tried something so simplistic and I totally get your frustration!
I am just a curious party on the internet and I’m looking on my phone so have done less deep digging than I would do at a desk.
Searching for Beko WMD service manual lead me to a site, elektrotanya.com where I got a file called beko_wmd_25121_t.rar which has exploded parts diagram and a fault code flowchart.
The flowchart says the following which may or may not be useful re resetting fault code.
The flow chart has details of the code flashings which I can give if helpful and you don’t acquire the document yourself.
Apologies if you’ve already tried something so simplistic and I totally get your frustration!